-
1
- #1
Hi there,
I'd like to change the printer settings to use different media for a Zebra S4M.
The media is reflective and has no underlying label, a black stripe and dotted line partitions each segment every 2.18cm on the roll of media.
I'm trying to set the Sensor Select from "Transmissive" to "Reflective"
Also, I try to change the Media type to "Mark".
Neither of these changes appear to be possible. When going through the options and selecting the parameters, pressing ENTER does not have any effect. It's only when I press menu that I get a response.
I'd like to change the printer settings to use different media for a Zebra S4M.
The media is reflective and has no underlying label, a black stripe and dotted line partitions each segment every 2.18cm on the roll of media.
I'm trying to set the Sensor Select from "Transmissive" to "Reflective"
Also, I try to change the Media type to "Mark".
Neither of these changes appear to be possible. When going through the options and selecting the parameters, pressing ENTER does not have any effect. It's only when I press menu that I get a response.