XNET CONFIGURATION - MITEL RELEASE 6

[ronmarc900]

Configured all 6 PBX's,PBX Numbers and their IP addresses on network elements, ICP/PBX - assigned IP addresses, IP/XNET TRUNK Profile done, IP/XNET trunk group done, COS,ARS, but the system can not recognise xnet when i use the state xnet all command, what did i miss?

 

[kwbMitel]

rmess verify PBX [highlight #FCE94F]X[/highlight] lan

run from each system to the other

if it does not connect, then your configuration is wrong.

**********************************************
What's most important is that you realise ... There is no spoon.

 

[SXWizard]

As kwbMitel suggests, check your connections using rmess verify. If you can connect successfully then you may want to use the Direct IP Route setting in Route Assignment instead of IP/XNET Trunk Group. All Direct IP needs for routing is the information in the ICP/PBX Networking form. You can leave the other 2 forms in IP/XNET blank. Very simple way to create IP Networking. Check IP Networking Programming>Using the Direct IP Route method in the Help files.