Lectrician
Technical User
Hi.
I have an XN120 with a 4 port BRI card. The four ports work when connected to an ISDN line.
I wanted to do some testing of the BRI incoming settings, and thought I could set two of the BRI ports to S mode (right clicking in card config, select ports). Also switching the polarity on the card on the two ports.
I just cannot get the SO mode working though, no dial tone to either a trunk connected to the SO port, or an ISDN test butt, although the layer 1 lights do illuminate on the card.
If I dial the assigned number for the SO extensions, the number 'hangs' the system phone for a few seconds, so something is trying to work.
Any pointers on getting this working? It's not because I need to, just because I want to! And not being able to get it working frustrates me!
Thanks!
I have an XN120 with a 4 port BRI card. The four ports work when connected to an ISDN line.
I wanted to do some testing of the BRI incoming settings, and thought I could set two of the BRI ports to S mode (right clicking in card config, select ports). Also switching the polarity on the card on the two ports.
I just cannot get the SO mode working though, no dial tone to either a trunk connected to the SO port, or an ISDN test butt, although the layer 1 lights do illuminate on the card.
If I dial the assigned number for the SO extensions, the number 'hangs' the system phone for a few seconds, so something is trying to work.
Any pointers on getting this working? It's not because I need to, just because I want to! And not being able to get it working frustrates me!
Thanks!
