Xerox Phaser 850 - How to Remove Covers?

[cloudninedesign]

Is there a reference that shows how to properly remove the Phaser 850's side covers, etc? I have the tech manual that shows how to repair my printer (Fault Code 08,001.44 - Cap Fault Home Sensor)and I have another 850 I can use for parts, but I can't find instructions on how to remove all the covers. Thanks!

 

[Michael52x]

Open top cover, and grip the edge and pull.
You will have to put tape on the flapper on the solonoid that is at the top right behind a plate. Remove two screws, and pull down. One screw to remove the solonoid.
Use canned air to blow out everything on both sides.Sensors, clutches, fans, and re-set all connections.
Good luck!

"Impatience will reward you with dissatisfaction" RMS Cosmics'97

 

[cloudninedesign]

Thanks.