Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

x450e-48p repeated power failure

Status
Not open for further replies.

gingirel

Technical User
May 29, 2012
1
RO
Hi all

I have a stack of 8 x450e-48p switches. I have many PCs and VoIp phones connected to them.
Slot 3 has 25 PCs and 13 VoIp phones connected. After ~1 month, the internal power source failed. I was able to run it without trouble using two external power sources, until the replacement arrived.
Yesterday I installed the replacement switch (new unit, not repaired). Over night, this one crashed too, but in a different way - when I arrived in the morning, all leds were flashing green-orange and all PoE power was down. The PCs were still connected to the network.
After a soft reboot and a hard reboot, I still have no PoE on any ports. I installed powere adapters to the phones and they work fine.
The internal power source does not show any error.
When running "show inline-power" on the stack, the command fails when querying slot 3:

Code:
Slot-1 Stack.18 # show inline-power
                Inline Power System Information
Configured                 : Enabled
Power Usage Threshold      : 70 percent (per slot)
Disconnect Precedence      : deny-port
                                       Budgeted       Measured
Inline-Power  Firmware Status    Power (Watts)  Power (Watts)   Legacy
1     Enabled       Operational         405 W           0 W           Disabled
2     Enabled       Operational         405 W           6 W           Disabled
Slot-1 Stack.19 #

My experience with Extreme Networks is short but painful, so any advice is welcome.
Thanks
 
What version of software are you running

Code:
show switch

Also do a
Code:
show stack

Windows Haiku:

Serious error.
All shortcuts have disappeared.
Screen. Mind. Both are blank.
 
Seems like you configured the new switch into the stack wrong I have seen this happen before. It's like the stack MAC is wrong on your new switch.

show logs
show stacking configuration
show stacking details
show stacking

Like w33mhz said ...Show switch would be helpful as well.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top