Hey, all.
I've got a pretty generic setup here, but for some reason I just cannot get this working correctly.
I have a WX1200 Wireless LAN Switch, and 4x 3750 3Com AP's to go with it. I've got a basic service and radio profile setup, with WEP authentication, but I cannot communicate with the network when I connect a device to the wireless network.
If I'm hard-wired in, I can ping everything on the network, have internet, etc.
However, as soon as I try to connect wirelessly, I cannot ping even the WX1200 itself, though I still get the "connected" status on the device. DHCP is setup off another router, however since I can't communicate with other devices, I end up having to hard-set my IP address. I only have the default VLAN setup, with ports 1-4 on the switch set for AP use. All WPA/WPA2/PSK authentication is turned off.
If this is a common problem that is easily remedied, great. Otherwise, I'd gladly post part(s) of my config here if need be. Unfortunately I'm not terribly fluent with 3Com programming, as this is my first attempt, but I've been at it long enough that I'm familiar with most of it.
Any help, advice, or tips would be greatly appreciated.
I've got a pretty generic setup here, but for some reason I just cannot get this working correctly.
I have a WX1200 Wireless LAN Switch, and 4x 3750 3Com AP's to go with it. I've got a basic service and radio profile setup, with WEP authentication, but I cannot communicate with the network when I connect a device to the wireless network.
If I'm hard-wired in, I can ping everything on the network, have internet, etc.
However, as soon as I try to connect wirelessly, I cannot ping even the WX1200 itself, though I still get the "connected" status on the device. DHCP is setup off another router, however since I can't communicate with other devices, I end up having to hard-set my IP address. I only have the default VLAN setup, with ports 1-4 on the switch set for AP use. All WPA/WPA2/PSK authentication is turned off.
If this is a common problem that is easily remedied, great. Otherwise, I'd gladly post part(s) of my config here if need be. Unfortunately I'm not terribly fluent with 3Com programming, as this is my first attempt, but I've been at it long enough that I'm familiar with most of it.
Any help, advice, or tips would be greatly appreciated.