WRT45G (Satori 4.0) + 2x WUSB45G @ only 1mbit :((

[Hephaistos]

Greetings!

I'm an absolut newbee @ WLAN. I bought myself two WRT45G and flashed them with the Satori 4.0 firmware. Done everything posted in this

http://www.tek-tips.com/viewthread.cfm?qid=837246

thread to configure one wrt45g as a bridge. Now I've got a problem: both client adapters (Linksys WUSB45G) are connected with only 1mbit (tried nearly everything in the router/bridge settings... "G-only", "54mbps", etc.).

A max of 84Kb/s throughput is more than low :/ Any ideas?

 

[bcastner]

The units will auto-stepdown as noise increases.

Try:

. The Michael Erskine parabolic reflectors. The EZ-12 takes just a few minutes to make:

http://www.freeantennas.com/

. Better antennas:

http://www.broadbandreports.com/forum/remark,11095954~mode=flat?hilite=antenna

 

[Hephaistos]

Thx for the quick answer. I'll try this tomorrow. But the joke is: this problem occurs even if the router or bridge is placed 1 meter in front of the usb wlan adapters. Allways a 1mbit connection only. :/

 

[Hephaistos]

uh uh uh uh ... getting mad. I found the error.

The WUSB45G driver cd was deliverd with the correct driver BUT when you install it via the setup.exe it overwrites existing drivers with the 802.11>>B<<-version without any warning.

Thx Linksys ... hmpf.

 

[kennz]

Don't worry about that. That only a Typo.