Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Wrong "5 minute input rates" shown on Interfaces

Status
Not open for further replies.
nadeep

nadeep

IS-IT--Management
Apr 15, 2002
3
LK

I have noticed that "5 minute input rate" info. which is availabe through for example "sh int s0" gives wrong values. E.g. I have a 128Kb link and the modem does not allow a higher throughput, however some times it shows
that " 5 minute input rate" is very much more than 128,000
bit/s. This I feel happens when I am down/up loading at max.
rates.
Any ideas why this?

Nadeep
 
Sort by date Sort by votes
Check that the command
bandwidth 128
is included in the serial line section of the router configuration.
 
Upvote 0 Downvote
Yes I have bandwidth set to 128, even though this has no effect, as if I am not mistaken this is for routing protocols to calculate the optimum path

Nadeep
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

woza
  • Locked
  • Question
GNS3: Delete the lines "transport preferred none"
Replies
1
Views
326
DrB0b
DrB0b
testman1
  • Locked
  • Question
SIP telephone ring on second call
Replies
0
Views
188
testman1
testman1
WinstonCH
  • Locked
  • Helpful tip
What is wrong with the diagram, there are people who will help to fix it? How do i do the configurat 1
Replies
1
Views
487
BIS
BIS
Skip Rango
  • Locked
  • Question
how to backup cisco sg500-52p switch
Replies
1
Views
351
madwok
madwok
darthvader167
  • Locked
  • Question
"Wait while I transfer your call"
Replies
0
Views
169
darthvader167
darthvader167

Part and Inventory Search

Sponsor

Back
Top