Word 2007 - Can't Save After Running Macro in Form

[JimLes]

I have a form in Word 2007 (.docm) made up of legacy and content controls. The form was fine until I plugged in a couple of macros for copying and pasting data and a spell checker because it is protected.

I can open and enable macros and then even save the document but after I run any macro, I get the message: "A File Error Has Occurred"

At this point I can only save the document as .doc or other format. The user needs to be able to save and reuse the document.

Anybody experience this? I have searched the web for a resolution but no luck. Even have the Hotfix for Word from Microsoft installed.

Thanks in advance!!

 

[kjv1611]

What is the code behind your macros? Are you using any objects in said code?

Also, have you tried recreating the document, in case it's a case of data corruption? Perhaps you have a backup copy you can test?

 

[JimLes]

Thanks to your advice, I reverted to a previous copy of my form and tested it. I was able to copy both macros, run them and save.

Not sure how the word document became corrupted. This has never happened to me before.

Thanks!!

 

[fumei]

Not sure how the word document became corrupted. "

Do not even bother trying to figure that out. Unfortunately, this happens with Word.

55,687.00 hours down....
22 hours to go

tick-tick tick-tick tick-tick