At work we are using a netgear DG834N router, some computers are hard wired and the laptops (XP Home) are wireless,We're not on a big company network, just an office and a house connected to the router. we're tryng to access the router setup page to disable the security so we can configure a Belkin range extender but we're unable to access the config page, we're using 192.168.0.1 but don't get anything, is it possible that whoever setup the router changed the ip address for the config page? if not then is there anything we can do to access the page or are we to just give netgear a call?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Wireless Netgear DG834N setup page
- Thread starter rodwf
- Start date
tlcscousin
Technical User
On one of the computerrs connected go to Start
Run
Type in CMD click OK
in the command prompt type in
ipconfig
hit enter
the default gateway is the IP address used to access the router.
Run
Type in CMD click OK
in the command prompt type in
ipconfig
hit enter
the default gateway is the IP address used to access the router.
- Status
Similar threads
- Locked
- Question