Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Westi on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

WinRoute v4.2.5 with Multiple IP addresses on One NIC interface

Status
Not open for further replies.
zenith518

zenith518

IS-IT--Management
Jul 6, 2003
4
CN
Hi, there!
because of Winroute firewall seems cannot support PPTP (I just switch to not screening the pptp interface), so I want to change to winroute pro 4.2, but there is a problem found recently, how it to support multiple IPs over one NIC, I try a lot, seems only can routing, but if I enable nat on primary ip network of that interface, the secondary ip network can not work properly. (of course, I used advanced NAT of winroute.)

Is there any recommandation config for this? Or this not supported by winroute pro?

Thank!

BR//Zenith
 
Status
Not open for further replies.

Similar threads

Sameer258
  • Locked
  • Question
Need Help to Find ip and mac address with email who one open my email
Replies
0
Views
775
Sameer258
Sameer258
XLNTech1
  • Locked
  • Question
iptables port forwarding
Replies
0
Views
582
XLNTech1
XLNTech1
Sparrow4
  • Locked
  • Question
Configure Avaya IPO R11 / VM Pro + Office365 or Exchange for voicemail to email
Replies
2
Views
642
Johnkite
Johnkite
Tommy_T
  • Locked
  • Question
Sonic wall - Have an issue remotely connectioning VNC and SMB (and AFP) to one of the 2 ISP circuits
Replies
1
Views
578
nnaarrnn
nnaarrnn
Russtoleum
  • Locked
  • Question
SW GVC won't route traffic through sonicwall to offsite tunnel unless it leases an ip on the same su
Replies
1
Views
180
Russtoleum
Russtoleum

Part and Inventory Search

Sponsor

Back
Top