Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

WIC-2AM-V2 Command Echo Problem

Status
Not open for further replies.
Aggie91

Aggie91

MIS
May 5, 2003
6
US
I put this over at the Cisco modem forum but that doesn't get much traffic.

I have the WIC in a 2921. When I telnet into it, the first character I type does not show up. When I type the 2nd character, the 1st then echoes. Typing the 3rd character then causes the 2nd to echo, etc.

This happens to everyone who Telnets into the modem. Issuing AT&F0 or F1 does not fix it. I dug through Cisco's WIC AT command doc but didn't find anything obvious.

Has anyone else experienced this? I have not experienced this on any other modem, Cisco or external.

Thanks,

Andy
 
Status
Not open for further replies.

Similar threads

DavidSigma
  • Locked
  • Question
CP7861 problem
Replies
0
Views
118
DavidSigma
DavidSigma
BleuBell
  • Locked
  • Question
Command Rejected : Exceeded NNI ports Allowed
Replies
0
Views
94
BleuBell
BleuBell
dogg1
  • Locked
  • Question
CUCM SNMP Set Command
Replies
1
Views
194
whykap
whykap
khashyar2021
  • Locked
  • Question
Problem with cisco switch after upgrading
Replies
1
Views
134
Geraldine Souza
Geraldine Souza
canflyguy
  • Locked
  • Question
Cisco RV-340 SIP problem
Replies
1
Views
114
DrB0b
DrB0b

Part and Inventory Search

Sponsor

Back
Top