Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Where do you enable Ports on a Windows 2000 Server?

Status
Not open for further replies.
Internetor

Internetor

IS-IT--Management
Mar 1, 2003
3
US
There must be an area where you can specify what ports to use for remote access in Windows 2000 server. This may be the reason for not connecting with a remote PCAnywhere 10.0 client because the port may not be open on the host side. The router's incoming log picks up the request. Note: firewall software on the server is not being used; port forwarding is enabled as is port triggering. What should I troubleshoot on both ends?

Internetor
 
Status
Not open for further replies.

Similar threads

tviman
  • Locked
  • Question
Do routers at each end of VPN tunnel need to be the same?
Replies
3
Views
152
tviman
tviman
Bubbalouie
  • Locked
  • Question
Looking for a recommendation on a branch router
Replies
6
Views
114
SYQUEST
SYQUEST
lharris1103
  • Locked
  • Question
Make a Linksys e2100l Router As a Switch
Replies
5
Views
145
lharris1103
lharris1103
03Explorer
  • Locked
  • Question
Tomato on WRT54G with Ooma
Replies
1
Views
78
SYQUEST
SYQUEST
wuzhounet
  • Locked
  • Question
Two Public Static IP address
Replies
3
Views
148
goombawaho
goombawaho

Part and Inventory Search

Sponsor

Back
Top