When manually entering keycode, getting Checksum Error

[viper222]

I am trying to manually enter a new keycode for CDP into LD 143. I type KMAN and it prompts me to enter Line 1 of my keycode. I enter Line 1 ok, then it prompts me for Line 2. Well, I enter line 2 and it comes back with a Checksum Error. I made sure I did not mess up on my multiple attempts but it will not take it. SO I try to do a KUPL and paste my keycode in, this also comes back with an error. I got these keycodes from Nortel. The disk set is in the mail but I needed this option ASAP. Is it possible that the keycode was generated incorrectly and even if I wait for the disk that it will STILL not work?

 

[luv2ski]

Solution ID: 1.0.13475293.1861475 Product Family: Enterprise Voice Create Date: 10/30/1998

Title:
Unable to input keycodes

Facts:
Commercial Processor Platforms

IODU/C


Symptoms:
Unable to input keycodes

System not accepting keycodes

Keycode checksum ERROR, Please type the last segment again.


Cause:
Entering keycodes as follows:
Line 1 >7TUS PLTW FC9G EFNL


Fix:

When entering keycodes manually, do not insert spaces between keycodes. Example:
Line 1 >7TUSPLTWFC9GEFNL

Refer to NTP P0872703, NT5D61 !ODU/C reference guide, Keycode management, LD43, under KMAN.








Pat Guido
NEXTIRAONE
Pat.guido@nextiraone.com

Formerly Nextira, formerly Williams Communications, formerly Wiltel, formerly Nortel networks, formerly Northern Telecom, formerly, Nynex meridian systems formerly Northern Telecom.

 

[viper222]

Thanks for the help. What actually happen is the keycode I got was 11 groups of 4 characters on one line about 7 lines deep. When I entered the first line I entered all 7 digits and it apparently took only the first 4 groups as Line 1. When I entered the second line it was not the true second line going by the 16 character format. I did it as 16 characters per line and all is AOK. Thank you luv2ski