Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
What's the sequence to upgrading Baystack 450 code?
- Thread starter mccartha
- Start date
hi ,
to upgrade your Baystack switches , you have to get two files the image and the diagnostic files ( .img & .bin ) these files are available in nortel website >> customer services >> software dist >> baystack switches
after getting the files ;
use a tftp server to transfere the files to the switch
from main menu >> software download >>
configure the ip address of the tftp server ( where the files are )
>>in diagnostic file field , put the path for your .bin file
>>using space bar select "diagnostic file trans"fere"
>> enter
the switch should transfere the new diagnostic file , after that it will reboot ,
next , you have to upgrade the image
>> software download >> image file path >> select image >> enter .. after that switch reboots with new image ..
you may find these steps well explained in the nortel website under "Customer service Bullitins " ..> BPS switch
Regsrds,
to upgrade your Baystack switches , you have to get two files the image and the diagnostic files ( .img & .bin ) these files are available in nortel website >> customer services >> software dist >> baystack switches
after getting the files ;
use a tftp server to transfere the files to the switch
from main menu >> software download >>
configure the ip address of the tftp server ( where the files are )
>>in diagnostic file field , put the path for your .bin file
>>using space bar select "diagnostic file trans"fere"
>> enter
the switch should transfere the new diagnostic file , after that it will reboot ,
next , you have to upgrade the image
>> software download >> image file path >> select image >> enter .. after that switch reboots with new image ..
you may find these steps well explained in the nortel website under "Customer service Bullitins " ..> BPS switch
Regsrds,
Get the latest code from the software distribution at:
Bob ^^
Bob ^^
If you are upgrading to rev 4.x there are two .img files required.
The files are loaded onto the switch via a tftp server following the the menu system on the console port.
The files must be loaded in the correct order, the first being the smaller of the two files.
If you are upgrading from an old release to most recent then Nortel advise that it is carried out in stages.
The files are loaded onto the switch via a tftp server following the the menu system on the console port.
The files must be loaded in the correct order, the first being the smaller of the two files.
If you are upgrading from an old release to most recent then Nortel advise that it is carried out in stages.
- Status
Similar threads
- Question
