Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations biv343 on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

what ld to use to run report on disu?

Status
Not open for further replies.

jimeec

MIS
May 29, 2003
207
US
Hi,I am re-wiring one of our comm. closets on sat.morn.My midnights run on my 81c @ 4:30am.I plan to print the AHST to show any disu before I start and what I would like to to do when I am done is run the midnights again to show any newly disu that may have not been x-wired correctly during the re-wiring process.Do I have to run the whole midnight routine again or can I run a specific overlay that will check the whole switch for disu's.I know I can do it shelf by shelf but I am striving for laziness..ahem,I mean time management.Could anyone advise on the ld's and procedures for the prompts?Thanks in advance.
 
You can go into LD 30 and just run a loop test.
LD 30
LOOP ALL
 
Thank you much Hawkes-exactly what I needed!
 
In LD32, use the LDIS l s, (l = loop & s = shelf)

this will display all disabled tn's for that l s
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top