What is the newest software for configuring a NEAX2400?

[skis]

I used to use the NEC MAT software to configure this but we lost our installer disk a while ago and every computer it was installed on has since been reformatted or the hard drive broke.

Is MAT still the software I should be using? If so, does anyone know where I can get it? I called a couple NEC vendors in my area and they said that NEC doesn't even sell it anymore.

I've seen MATWorX mentioned while digging online but I can't tell for sure if that works with my Univerge NEAX 2400 IPX.

Any help/insight anyone could provide would be greatly appreciated.

 

[belevedere]

If your software version is R 5 or higher you can use the newer PCPro for the SV-8500. However you can only get it from a dealer. It is a free download to an authorized dealer.

 

[skis]

Is there any way I can tell what my software version is without access to any configuration software?

 

[belevedere]

If you can log in, go to command DISS and select MM (main memory).
Or, if you have the installation CD or disks it will be noted on them.