What does this mean 2

[altolabado]

# LD 32 program identifier.
.stat 8 0 1

00 = UNIT 00 = IDLE (TRK)(CO GRD )
01 = UNIT 01 = UNEQ
02 = UNIT 02 = UNEQ
03 = UNIT 03 = UNEQ
04 = UNIT 04 = IDLE (TRK)(CO GRD )
05 = UNIT 05 = UNEQ
06 = UNIT 06 = UNEQ
07 = UNIT 07 = UNEQ
.

 

[mikeyb123]

you have 2 analogue lines connected to ports 0 and 4 of the card.

the rest are unused.

if you do a prt of the TNB ie

ld 20
req = prt
type = tnb
tn = 8 0 1 0

it'll tell you wnat route these trunks are in (RTMB)

then go into ld 21
and prt the rdb and it might tell you what its for

It's not getting any smarter out there. You have to come to terms with stupidity, and make it work for you.

 

[johnpoole]

those are old analog trunks, sorta like a single trunk on a t1, go to load 21 and do a ltm enter enter enter that will show these trunks and all other hidden trunks, look up the commands in 36 for trunks that have been idle for over x days.. that might help determine if there still used. try to dial tha acod see if you can call out. once you see the route in 21 go to ld 86 and REQ prt CUST 0 FEAT rlb RLI enter.. that will tell you if anything is pointed to that route.. then in 90 prt net 0 ac1(for dial 9) npa enter..there's all the 1+ pointed to a rlb..same command but nxx..there all the local numbers pointed to each rlb. chances are those were once used for power fail, and as a second entry in a rlb. so if the entry 0 is full or down you have a sec way out. i have a cot (central office trunk) in my local rlb with a frl of 12, if my local pri's are busy or down, 11 of them, you need a ncos of 12 or higher to get out on the only trunk. one phone has that ncos, mine, so i can call the co, or my boss or most important, my wife..



john poole
bellsouth business
columbia,sc