Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

What are the standard T1 PRI configurations to verify with PBX and carrier?

Status
Not open for further replies.

Irvineca949

Technical User
Jan 31, 2011
151
US
I need to verify Verizon has the same T1 configurations for my PRI T1 going to a S8800 rl.5.2.
Besides the setting below, what are other settings I need to verify with Verizon?
T1 - b8zs/esf
robbed bit
no echo noise cancelling
 
ISDN-PRI should not be configured as robbed-bit.

In addition to b8zs/ESF, you will need to find out if they are using AT&T Custom protol or NI 2. Below is a screen shot from one of the ISDN circuits in my lab.

Kevin


DS1 CIRCUIT PACK

Location: 01A08 Name: Circuit ID
Bit Rate: 1.544 Line Coding: b8zs
Line Compensation: 1 Framing Mode: esf
Signaling Mode: isdn-pri
Connect: network
TN-C7 Long Timers? n Country Protocol: 1
Interworking Message: PROGress Protocol Version: a
Interface Companding: mulaw CRC? n
Idle Code: 11111111
DCP/Analog Bearer Capability: 3.1kHz

T303 Timer(sec): 4


Slip Detection? y Near-end CSU Type: integrated

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top