We have a Meridian CS1000M and we c

[richardsgs]

We have a Meridian CS1000M and we currently are required to dial 16 then a PIN to access the long distance trunk. We are looking to eliminate the PIN requirement. Any suggestions on the steps to take to do so would be appreciated. Thank you

 

[Firebird Scrambler]

It sounds as if you are using some sort of Auth code to access the lines after keying in "16". You need to find out what "16" in the CS1000 programming.

It's best to download the attached guide and find out in DNB what is going on. You might also need to go into LD 88 for Auth codes etc.

Firebird Scrambler

Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer

Website =

http://somertel.com

linkedin

 

[richardsgs]

I believe that the 1 is a SPRE code for this system and the 6 is the follow on for authorization code access. Once you dial 16 plus your PIN you receive dial tone - hit the LD trunk.