I have an AP00-A card that was installed with the 2000IVS system 6 years ago. I tried to go into CMD000 and I get "HARD WARE ERROR". In CM08 the card is set properly. The sense wheel is correct and not conflicting. It's still in original slot, 2nd PIM AP6/FPC slot. Lights are on, dip switches are all to the right (Changed switch 2 and 3 to left like SMDR manual says for initializing). I'm wondering if the card is bad, is there any way to find out if the card is bad, or if the card is good and I simply need to make changes in certain commands?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Way to test AP00-A card?
- Thread starter osurob
- Start date
Make sure you do not have an AP00-A DBM card used for wireless roaming. The hardware is identical but the Eproms are different.
Check the small sticker on the bottom RH corner or check the chips on the card. Make sure you so not see DBM (data base management).
Check the small sticker on the bottom RH corner or check the chips on the card. Make sure you so not see DBM (data base management).
- Status
Similar threads
- Locked
- Question
- Locked
- Question
