wanting NAT to complete my network.

[surfandsand]

I have a win2k server box with dhcp, DNS, and all other needed essentials to get RRAS and NAT going but I am running into inssues and Iam not sure what they are. Can someone point me to a THREAD or a FAQ to review to see if I hafve it set up correctly?

 

[Daveyboy2]

Why would you need NAT running on your server?

I don't think you will get a reply, there are too many opinions on what a good build entails, and you aren't mentioning what your problems are.

 

[oceanid1]

start routing and remote access go through the wizard select nat as the option. select your public address when prompted at that point it will install rras click finish
expand ip routing go to the properties of nat/basic firwall address assignment select automaticaly, input your net address(192.168.0.0) not an ip address(192.168.0.1) and exclude you dns server, dhcp server, router etc. from the list.
basically that is it for move advance setup there is to much stuff to cover hope this helps