Want to remove PRI Card and use 2 POTS lines

[nooop]

My system is MICS with only a Combo card and a PRI card. I need to use 2 POTS lines and no longer will be using the T1. I don't know what card I need and if keycodes are required like BCM. I don't know too much about MICS and I did browse FAQ. Do I just get a Global Analog 4 port CLID card and put it in the slot and cross connect my pairs? Leave the PRI card there or pull it out?
Thanks

 

[allworxguy]

No keycodes required

Remove the Digital Line Card and install the Analog line card in slot 4

If you ever want to put the DTI card back in and use the PRI again, DO NOT remove the combo card or you will cause a cold restart and lose your PRI keycode.

Marv ccna

http://www.telemarv.ca

Sales, Installation & Service for Norstar, BCM, Samsung & Allworx Serving Ottawa and Eastern Ontario since 1990

 

[curlycord]

Best to leave DTI card in and just add the card.





________________________________________
We take the time to try to answer your questions for free, please return the favor and take the time to answer back and include any resolution you found elsewhere, thanks.

=----(((((((((()----=

http://www.curlycord.com

Toronto Canada

http://www.telcopc.ca

 

[exsmogger]

I agree with curlycord. Leave the DTI card in slot 4 and put the caller ID card in slot 3. Assuming your software level is at least R6.0 you will program lines 031-034 for the card in slot 3. If it's lower than R6.0 you will program lines 025-028.

Brian Cox
Georgia Telephone

http://Georgia-Telephone.com

http://www.linkedin.com/in/briancox1952