WAG54G VPN Passthrough

[wattie29]

Any ideas?

I connect to my office via a Cisco VPN client and a PIX firewall. This works great as long as I connect to the hub on the ADSL gateway.

However when I run it through the wireless adaptor, I can authenticate with the firewall but the channel does not secure.

 

[cdogg]

Did you enable the "IPSEC passthrough" setting on the router?


~cdogg
[tab]"All paid jobs absorb and degrade the mind";
[tab][tab]- Aristotle
[tab][navy]For general rules and guidelines to get better answers, click here:[/navy] faq219-2884

 

[wattie29]

Yip as I say, it works through the router but only on the hub, not wirelessly.

 

[cdogg]

Yep, that's an issue my company has been dealing with over the past 6 months. As more and more people are moving wireless, it was just a matter of time before the issue came to our attention.

If you find an answer, please post back. As far as I know, the issue only exists over wireless and has something to do with the setting on the WAN side (nothing you can change in your configuration will help). At least that's how I understand it.

Anyone reading this feel free to chime in...


~cdogg
[tab]"All paid jobs absorb and degrade the mind";
[tab][tab]- Aristotle
[tab][navy]For general rules and guidelines to get better answers, click here:[/navy] faq219-2884

 

[bcastner]

. Use Cisco client 4.0x (check for latest)
. Set the MTU on the client to 1400.

http://cco.cisco.com/en/US/products...ts_tech_note09186a008009483d.shtml#subtopic1B