Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

VWIC-2MFT-E1 Configuration for Dial-up Access

Status
Not open for further replies.
bayo72

bayo72

ISP
Oct 23, 2009
1
0
0
NG
Dear all,
I need help to configure my Cisco 2611xm router (12.3(3a) IOS)with VWIC-2MFT-E1 module as a dial-up server.
I am new to this so I require help to accomplish this. From the installation of the card to the actual configurations required to accomplish this aim. Thanks all.
 
Sort by date Sort by votes
Go and hire someone to do this for you.

[americanflag] Go Army!
Tek-TIP Member 19,650
CCNA, CCNA Voice, CCNP, CCVP
Avaya IP Office 500, CS1000
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

jarod_paris
  • Locked
  • Question
firmware for an AP2800 WiFi terminal
Replies
0
Views
69
jarod_paris
jarod_paris
bfordz
  • Locked
  • Question
new help on setting up third party VoIP phones through Catalyst 2960x switch
Replies
0
Views
52
bfordz
bfordz
disk-us
  • Locked
  • Question
RTU licensing for a901
Replies
0
Views
34
disk-us
disk-us
quazimotto
  • Locked
  • Question
Cisco ASA_5505 VPN to Juniper_SRX210 VPN IS UP_ No Traffic!!!!!!
Replies
0
Views
37
quazimotto
quazimotto
msk69
  • Locked
  • Question
CISCO 7942 Phone Upgrading to SIP
Replies
0
Views
56
msk69
msk69

Part and Inventory Search

Sponsor

Back
Top