dsimpaired
MIS
Are there any changes with vrepair & nw 6.5? When I dismount a volume and run vrepair it states that there are no volumes defined.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Vrepair & Netware 6.5 1
- Thread starter dsimpaired
- Start date
- Status
-
1
- #2
marvhuffaker
MIS
You cannot run vrepair on NSS volumes. Only traditional volumes.
The way to check and/or repair NSS volumes (by pool,actually), is to do the following:
NSS /POOLVERIFY (menu comes up, select the pool).
NSS /POOLREBUILD (same)
Do a verify first. If there are any errors, then I would rebuild it.
Remember that you're not repairing volumes, you're reparing pools.. A pool can contain numerous volumes.
Marvin Huffaker MCNE, CNE
Marvin Huffaker Consulting
The way to check and/or repair NSS volumes (by pool,actually), is to do the following:
NSS /POOLVERIFY (menu comes up, select the pool).
NSS /POOLREBUILD (same)
Do a verify first. If there are any errors, then I would rebuild it.
Remember that you're not repairing volumes, you're reparing pools.. A pool can contain numerous volumes.
Marvin Huffaker MCNE, CNE
Marvin Huffaker Consulting
- Thread starter
- #3
dsimpaired
MIS
That's it, thanks. We have been running 5.1 with traditional vols for so long this is new to us!
- Status
Similar threads
- Locked
- Question
- Locked
- Question