VPN Phone and Watchguard XTM25 1

[Pepp77]

Has anyone got one working, I have been working on setting one up and can get it to create the VPN, but then the phone instantly goes into Discover, then connecting, then tries to do the VPN again and this times fails with Phase 2 Failure. Retrying brings the same result with Phase 2 failure, whilst a reboot completes the whole routine.

Any help appreciated.

| ACSS SME |

 

[teletechman]

Tried this a while ago and got the same results finally put in a Sonicwall to get the VPN phones working. Never could get them working with the Watchguard.
Mike

 

[ctvi]

Did anyone get it to work with CISCO RV320?

http://www.ctvi.com

 

[hairlessupportmonkey]

it does work with an XTM 25

You need to use the the Juniper profile and match the IPSec settings as set by the XTM25

I used to do them all the time with the last company.

ACSS - SME
General Geek