VPN not syncing when upgrading from PRO200 to NSA2400

[caremaster]

I am replacing a pro200 with a nsa2400. I have a couple of VPNs to TZ150s and the new 2400 does not make a tunnel.

The first log entry is this:
Info - VPN IKE - IKE Responder: Received Aggressive Mode request (Phase 1)
Second entry is this:
Warning - VPN IKE - IKE Responder: Proposed IKE ID mismatch

Question: Do I have to change something on the TX150 vpn setup to make the new tunnel?

 

[joepc]

Do you a Dynamic WAN IP address? If not use main mode rather than aggerssive mode.

Also check the encryption settings etc. They need to match at both ends.