vpn client (windows to pix) there is no internet connection

[mmkcia]

hi all
i have cisco pix 506e configured as vpdn server as following



route outside 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx 1
access-list inside_outbound_nat0_acl permit ip any 10.100.100.192 255.255.255.224
nat (inside) 0 access-list inside_outbound_nat0_acl
nat (inside) 1 0.0.0.0 0.0.0.0 0 0
global (outside) 1 interface
ip local pool remote 10.100.100.200-10.100.100.210
sysopt connection permit-pptp
vpdn group PPTP-VPDN-GROUP accept dialin pptp
vpdn group PPTP-VPDN-GROUP ppp authentication pap
vpdn group PPTP-VPDN-GROUP ppp authentication chap
vpdn group PPTP-VPDN-GROUP ppp authentication mschap
vpdn group PPTP-VPDN-GROUP ppp encryption mppe auto
vpdn group PPTP-VPDN-GROUP client configuration address local remote
vpdn group PPTP-VPDN-GROUP client configuration dns 4.2.2.2
vpdn group PPTP-VPDN-GROUP pptp echo 60
vpdn group PPTP-VPDN-GROUP client authentication local
vpdn username xxx password xxx
vpdn enable outside



when client connect to it internet gone
i got the same configuration in mikrotik router but when i connect there is internet
is it natting problem i dont think so
i think something with dns server


moustafa m kaid
ccna
commium group
iraq

 

[NetworkGhost]

You will not be able to connect to the internet while using the windows VPN client to the PIX. YOu can enable split tunneling and use the Cisco VPN Client which is free and can be downloaded from Cisco.

Free Firewall/Network/Systems Support-

http://firewalls.ath.cx

 

[dapCZ]

split tunneling is not good solution (security reason). Better way for access to internet is using proxy server (if you have proxy server) on inside network .