Hi all, I have a setup here where we have 2 private networks. One is on the end of a SonicWall, and the other is on the end of a Cisco PIX 525.
Our customer is on the end of the SonicWall 10.1.0.0/16
Our PIX is at 192.168.0.0/16
We have a VPN tunnel setup between the two locations. Right now, we are able to fully route IP from both sides.
The reason we have a VPN tunnel setup is because we want to be able to access some of the devices on the customers network behind the SonicWall, however, we don't want the customer to be able to just access anything on our network. What I would like to be able to do is be able to put them through the standard "firewall" rule sets, so I am able to open ports to specific ports on hosts on our 192.168 network. Is there a way to do this? If so, how would I set it up?
Our customer is on the end of the SonicWall 10.1.0.0/16
Our PIX is at 192.168.0.0/16
We have a VPN tunnel setup between the two locations. Right now, we are able to fully route IP from both sides.
The reason we have a VPN tunnel setup is because we want to be able to access some of the devices on the customers network behind the SonicWall, however, we don't want the customer to be able to just access anything on our network. What I would like to be able to do is be able to put them through the standard "firewall" rule sets, so I am able to open ports to specific ports on hosts on our 192.168 network. Is there a way to do this? If so, how would I set it up?