Vpath: After reconfiguration 0 devices (0 disks * 8 slices)

[sanmi]

After installing qla2300, IBM sdd driver, SAN - Storage TEK software SANsurfer cli & the appopriate patch on my server,

vpath does not see the assigned disk for the HBA.
Vpath: After reconfiguration 0 devices (0 disks * 8 slices)

When I ran cfg command, I get the following:

# cfgadm -al
Ap_Id Type Receptacle Occupant Condition
c0 scsi-bus connected configured unknown
c0::dsk/c0t0d0 CD-ROM connected configured unknown
c1 scsi-bus connected configured unknown
c1::dsk/c1t0d0 disk connected configured unknown
c1::dsk/c1t1d0 disk connected configured unknown
c2 scsi-bus connected
unconfigured unknown
c3 fc-fabric connected unconfigured unknown
c3::5005076300cc9b00 disk connected unconfigured unknown
c3::5005076300d09b00 disk connected unconfigured unknown
c4 fc-fabric connected unconfigured unknown
c4::5005076300c49b00 disk connected unconfigured unknown
c4::5005076300c89b00 disk connected unconfigured unknown
#

When I ran the format command I don't see the additional disk.
# format
Searching for disks...done


AVAILABLE DISK SELECTIONS:
0. c1t0d0 <SUN72G cyl 14087 alt 2 hd 24 sec 424>
/pci@1c,600000/scsi@2/sd@0,0
1. c1t1d0 <SUN72G cyl 14087 alt 2 hd 24 sec 424>
/pci@1c,600000/scsi@2/sd@1,0
Specify disk (enter its number):


Any help is appreciated.
Thanks,
Sanmi