I have a BCM 3.6 today with 4- H.323 trunks that we purchased. Can I dial an 8 or 7 and pull dial tone from my remote switch using an exisiting WAN that comes back to my main office? I have an opt. 81C with Succssion 4.0 and a siganling server in place today at my main site.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
VOIP Trunking
- Thread starter 1000M
- Start date
you could set up a access code to the VOIP lines and in call routing have the 8 converted to an access code on the meridan or you could have 8 as the access code and in call routing tell the system to strip 0 digits.
Then on the meridan have an 8 as the access code set up and point to the route you want the calls to leave by.
You could for example have the user on the BCM dial 8 and have call routing absorb the 8 and output 9 accross the link this will pickup the route on the meridan and dial out providing the VOIP lines are configured correctly on the meridian.
Hope this makes sense
Then on the meridan have an 8 as the access code set up and point to the route you want the calls to leave by.
You could for example have the user on the BCM dial 8 and have call routing absorb the 8 and output 9 accross the link this will pickup the route on the meridan and dial out providing the VOIP lines are configured correctly on the meridian.
Hope this makes sense
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question