Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

VOIP Settings in BCM

Status
Not open for further replies.

spooktheblackcat

Technical User
Dec 2, 2005
9
GB
I have set up a VPN using Office Connect with BSR 222 and BCM 50 at both ends. The VPN is establihed OK. I was intending to set up a linked numbering scheme to dial direct between system extns, ie extn 2xx at site A and extn 3xx at site B. What I'm not sure is what settings (if any)on the BCM need inputting to allow voice calls. I have created a route for level 2 and level 3 at the respective sites to use the VOIP trunks, and the received numbers are set up also. Any advice on how to complete this set up would be very much appreciated.
 
Go under resources-tel resources-IP trunks-then under routing table enter the IP's of sight A and sight B's router with destination digits being the dest codes of the routes you build.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top