Voip networking

[Chamvari]

I have a many question about the Tda 600 i managed to go through the manuals and linked two systems tda600 & 200 sing the Ip gw 16 Card with 16 port. the dialing plan is very shallow , why do i have to pick a tie line to dail the networked system. the system have unique numbering plan. i thought its suppose to be extension to extnsion, but you to dial 8 digits and a # to get to the networked system .

Dial Tone shoul be There

 

[jonjoeni]

Hi Chamvari,
There are two ways to set up the dialing plan and you have gone for the site code option. If you look up the manual you can dial via extension by taking the extension numbers of the remote site out of the numbering plan of the local site. Then set the system so that for example 3?? is pointed at the gateway.You will need to set up the remote to accept 3?? from its gateway. Sorry no alternative but go through the manual step by step I have a 600 & 2 NCP's linked like this.

 

[Chamvari]

I ma not very good on the system i am still learning i more into lg nortel and its straight forward. Let me read again the manual then. All this programming is on the gateway or system programming.

Dial Tone shoul be There

 

[cwc3]

yes you don't have you dialing plan set up properly.....

 

[AGComms]

you also need to log onto the IP Gateway cards to setup youre routing, so read manual on IPGW Card set up too.