Voip.ms

[mjwald]

I am trying to get a 2811 to register with voip.ms, can't quite get it.
It does not even appear to be trying to register
This is what i have below

On the voip.ms site they have a config guide for IOS 15.1, but I am still running 12.4 and more then a few of the commands do not work for me.



version 12.4

!
!
voice service voip
allow-connections sip to sip
sip
registrar server
!
!
sip-ua
authentication username XXXXXX password XXXXXX realm chicago.voip.ms
calling-info pstn-to-sip from number set 1XXXXXX0010
no remote-party-id
retry register 10
registrar dns:chicago.voip.ms expires 3600
registrar ipv4:208.100.39.52 expires 3600 secondary
!

 

[ReallyRotten]

Here is some of what I have. Do you the correct interfaces set up (i.e. g0/1 is bound to the service provider and g0/0 is bound to CUCM). Hope this helps.
!
voice service voip
no ip address trusted authenticate
address-hiding
mode border-element license capacity 25
allow-connections h323 to h323
allow-connections h323 to sip
allow-connections sip to h323
allow-connections sip to sip
redirect ip2ip
signaling forward unconditional
fax protocol pass-through g711ulaw
sip
rel1xx disable
header-passing
error-passthru
referto-passing
asserted-id pai
asymmetric payload dtmf
early-offer forced
midcall-signaling passthru
privacy-policy passthru[tt][/tt]

!
!
sip-ua
credentials username ##### password 7 ##### realm Realm
authentication username 2507435221 password 7 #####
no remote-party-id
retry invite 2
retry register 10
timers connect 100
registrar ipv4:10.1.1.1:5060 expires 3600
sip-server ipv4:10.1.1.1:5060
!
!

 

[mjwald]

ReallyRotten,
Been rather busy the last week or so. SO slow getting back to you

" Do you the correct interfaces set up (i.e. g0/1 is bound to the service provider and g0/0 is bound to CUCM). Hope this helps."

in short NO.
I was not even using two interfaces, all communications are running from int fa0/0.
Can I just bind loopback interfaces to cucm and the sip provider?


Thanks Much!