VoIP and Adtran 3200 802.1q problems

[jeter]

Has anyone had the problem with the VoIP trunks not disconnecting over a PPP T1 to another BCM


BCM 200--->Netgear switch--->Adtran 3200 router 802.1q---

T1 PPP

Adtran 3200 router 802.1q--> Bay Stack 425T---> BCM 50

ALso any configs on the Adtran 802.1q configs would be nice I'm having problem on my second sub interface pinging my local network.

“Reserve your right to think, for even to think wrongly is better than not to think at all”

CCNA,CCNP,CIPT, Network+
Tek-TIP Member 19,650

 

[jeter]

NOTE: this 802.1q problems have been resolved but I still have problems on the VoIP trunks locking up.

“Reserve your right to think, for even to think wrongly is better than not to think at all”

CCNA,CCNP,CIPT, Network+
Tek-TIP Member 19,650

 

[jeter]

VoIP problems resolved. The problem was two fold the original installer installed several I2002 and I2004 ip sets and piggy back desktop computers. This requiring 802.1q trucking to allow both VLAN ports for voice and data. The other was several sets had the wrong gateway it was pointing to the BCM rather than the router.

“Reserve your right to think, for even to think wrongly is better than not to think at all”

CCNA,CCNP,CIPT, Network+
Tek-TIP Member 19,650