Voice and data integration

[ziobrtw]

I would like the ability to integrate our voice and data communications over T1 using a CISCO 2610. We have a Nortel Modular ICS phone system. Questions:

Which VWIC and modules would I need to accomplish this?
How is the physical connection to the phone system accomplished?

Forgive me, this is an area which I am very much a novice.

Thanks.

 

[jeter]

You can run voice over frame relay using E&M lines from your nortel modular ics.
Type 2, 4 wire E&M, setup to autoanswer and wink-start . Equipment needed for this is an E&M tie line card, and a voice card for the router . Check with cisco for the correct parts . Looking at the 2610 it looks like you should be able to work this with no trouble . good luck !!!