VoFR and Caller ID

[MBowman]

Does anyone know if it is possible to send caller id information over VoFR. I have 48 sites all with MC3810 tied back to a core 7206. The 7206 then runs to a Lucent switch.

All sites have a Full Frame Relay T1 running to the core.

I can make calls over frame-to-frame and from PBX-to-frame no problem. However I lose caller id information when making a call from the frame side or lucent to frame side.

Thank you in advance for any help,
-Matt Bowman
CCNP MCSE

 

[jeter]

Here are some sites you may want to check out.

http://www.cisco.com/univercd/cc/td...newft/121limit/121x/121xh/121xh_2/dt_clid.htm

http://www.cisco.com/warp/public/cc/pd/iosw/iore/prodlit/1262_pp.htm

I hope these sites will help you out!

Jeter@LasVegas.com
J.Fisher CCNA

 

[MBowman]

Thank you for the reply.

I have tried these steps on the cisco website. I still can not make this work properly. Is there anyone out there that might have a sample config, or can answer a few question please let me know.

Thank you again!

-Matt Bowman
CCNP MCSE

 

[jeter]

I have not worked much on the 3810 so I do not have any configs. I will check the Cisco web site again, maybe we will get lucky. Jeter@LasVegas.com
J.Fisher CCNA