vm pro connect lines

[jeepguy267]

I am working on a vm pro that has decided to stop allowing me to draw connecting lines between tokens. I had one do this once before for a few minutes and I just kept trying different things until it came back up. I have tried reboot, start and stop service as well as delete, add, change tokena and aspects of tokens. No luck.

Anybody else come across this strange bug? any way to get it going?

 

[IPGuru]

I have found that if the action is to far to the left of the start then VM pro will not allow connection

 

[jeepguy267]

Thanks for posting. Nothing strange on the placement of tokens. I was mostly rearranging where the touch tones pointed.

I ended up creating a new module and copying tokens to that new mod. I could draw lines in the new mod just fine and then I went back to the original and it let me draw 2-3 lines before quiting. I just kept going back and forth between the mods and was able to get what i needed done. If I had to make more changes I probably would have just recreated the whole auto attendant in the new module and then end up dumping the original one all together. Very buggy and cumbersome to get through.