Vlan Trunking

[AlfredSpecial]

Hello everyone.

How do i go about trunking two 2650s together via a 10/100 port to carry vlan traffic between them.I am using the default vlan1 and a voice vlan10?

I always thought you just tagged/untagged the port used for the uplink. I cannot find any documentation on trunking.

thanks

 

[Lundah]

The way I've done this is by assigning the trunk port to each VLAN you are placing on the trunk, then selecting the tagging option. Should work, I've set up inter-VLAN routing this way, placing both VLANS on the port, then using subinterfaces on the router (in my case a Cisco 2621) for each VLAN.