Vlan Configuration on Procurve 5304xl

[Cavalieri]

Network based on VLAN10.(Schematic 1)

VLAN10 IP ON SWITCH BULDING 1 IS: 192.168.10.1 (default gateway)
VLAN10 IP ON SWITCH BULDING 2 IS: 192.168.10.2
VLAN10 IP ON SWITCH BULDING 3 IS: 192.168.10.3
VLAN10 IP ON SWITCH BULDING 4 IS: 192.168.10.25

HOST’S GROUP “A & B” ARE WORKING ON SAME VLAN10 WITH STATIC IP: 192.168.10.X and GT: 192.168.10.1

HOST’S “A” ARE ABLE TO GO TO INTERNET: DNS 192.168.10.6 ALT DNS: 192.168.10.9 and they HAVE NOT TO BE ABLE TO GO TO REMOTE LAN .
HOST’S”B” ARE ABLE TO GO TO REMOTE LAN: DNS 192.168.10.5 ALT DNS: 192.168.10.7 and they HAVE NOT TO BE ABLE TO GO TO INTERNET.

HOST’S “A & B” ARE ABLE TO COMMUNICATE EACH OTHER.

ALL SWITCHES HAVE A STATIC TABLE ROUTING:

0.0.0.0/0 192.168.10.4 all traffic goes to remote LAN.
10.0.0.0/8 192.168.10.11 rest of traffic goes to internet.

Everything is working really fine.

Now I need to add more Host’s so I will need more IP’s. I created more VLAN’’S and now my network has 4 VLAN’S but I do not know how to configure the switches and VLAN’s.

VLAN10 192.168.10.X Bulding 1 (Host’s A & B)
VLAN20 192.168.20.X Bulding 2 (Host’s A & B)
VLAN30 192.168.30.X Bulding 3 (Host’s A & B)
VLAN40 192.168.40.X Bulding 4 (Host’s A & B)

I would like to have same services on both group’s of Host’s A & B and of course they need to communicate each other (I mean Host’s A & B are able to communicate with all other host’s on different VLAN’s). How can I configure my switches?
My network should be like the schematic 2 .

 

[Bas1234]

Better to place this in the HP thread.

http://www.tek-tips.com/threadminder.cfm?pid=777

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________