Guest_imported
New member
- Jan 1, 1970
- 0
Dear Expert in Visual C++,
I need a sample Visual C++ code that enable me to send a stream of pulses (with control over duty cycle and number of pulses) to the serial port COM1 or COM2. I then can couple these pulses to a driver and condition them to be connect to a DAC with Serial input. It would be nice also to have a contorl over the second port COM2 at the same time, so at the end of the stream bits from COM1 I can issue a pulse from COM2. Otherwise I can use only COM1 and somehow isolate the very last bit to use as enable or latch.
Wireless Jazz.
I need a sample Visual C++ code that enable me to send a stream of pulses (with control over duty cycle and number of pulses) to the serial port COM1 or COM2. I then can couple these pulses to a driver and condition them to be connect to a DAC with Serial input. It would be nice also to have a contorl over the second port COM2 at the same time, so at the end of the stream bits from COM1 I can issue a pulse from COM2. Otherwise I can use only COM1 and somehow isolate the very last bit to use as enable or latch.
Wireless Jazz.