Visionfs NETBIOS problem

[lanman77]

I am running SCO 5.05 and want to connect to Windows 2000 box using Visionfs (newest flavour). First off on the SCO box I have a Netbios application that needs to run as the primary app and listen over tcp port 139 and udp port 137 and 138 and can not be changed.
In Visionfs profeditor it allows you to change the port to make it the secondary app. However when I update the visionfs server then restart it I never get my Unix prompt back until I hit the enter key(dont know if it even updated the profile) then when I restart all the services visionfs
gives me an error message that port 139 138 and 137 are in used and never starts. What can I do to make Visionfs listen on another port?
The only thing the Visionfs docs indicated is that you change the port and stop names in the profeditor.

Mike

 

[pcunix]

I'm confused.

What good would it do to have Vision work on a different port? The Windows browsers aren't going to use anything different.

You can bind it to a different network card- would that solve your problem? Tony Lawrence
SCO Unix/Linux Resources

http://pcunix.com

tony@pcunix.com

 

[lanman77]

yes I see your point. I will have to try installing a second card and see where that gets me.
thank for the reply
Michael

 

[Guest_imported]

Se me daño mi systema Sco Unix 3.2 y al tratar de restablecerlo me dice que no encuentar el servicio routed/udp y con esto no puedo entrar a mi red, si puedo hacer ping al server pero no puedo entrat con un telnet.

podrian ayudrame

 

[stanhubble]

Babelfish translation:
I am damaged my systema Sco UNIX 3,2 and when trying to restore it it says me that not to encuentar the service routed/udp and with this I cannot enter my network, if I can do ping to the server but I cannot entrat with a telnet.

Sounds like the restore was not complete.
check /etc/services and /etc/inetd.conf

Los sonidos como el restore no eran y completo /etc/inetd.conf del cheque /etc/services