VIOP Gateway Not Ringing

[adame11]

I have 2 Bcm 50 Rls 2.0 witch i have setup over a VPN. Both Sites A&B have 2 VOIP gateways keycodes installed. I'm able to call from site A to B. Site B phones will ring but when I answer there is no Speech. If I call from site B to A nothing happens. Although when I log onto BCM monitor I can see the call go out site B over Line 002(Voip), then into site A on Line 001(Voip). I can also see it translate the dialing string and ring the appropriate Target Line.

As far as Target Line Programing Goes I have The line type set to the Dn and the Rec'vd # set the the Dn. I also assigned the according Dn To Ring.

Any Suggestions??

 

[PainOfDeath]

I just went through a very similar setup with my vendor and there are a lot of things that need to be configured for this to work right. In our setup we also purchased MCDN keycodes. Are your routes and destination codes set up correctly? Do you have the correct settings for your VoIP trunks under Telephony resources? Of course none of this will work if you have VPN issues. My suggestion is to get someone qualified to help you out.

For the record, those of you who have seen my previous posts on the troubles I was having with MCDN will be happy to know that my vendor stepped in and resolved all the issues.

 

[adame11]

I have set up many of these systems, i am a qualified installer I was just wondering if anyone else has had this simlar problem with the 2.0 the destination codes and routes are programed correctly if you read the hole question you would have seen that the call is going out of the system and into the far end system ringing the correct target line just the set itself does not ring