telemarksman
Vendor
I am resurrecting this older thread with a twist.
I put in an ACS R6 for customer who had an older IP Office ( not sure if it was the original type?) that he did not like.
He had an existing Viking PA2A paging / loud ringer combo already setup.
Now when he hits the all page button I think it is *70, but it may be *71?
Anyhow, because he is an older gentleman he does not hang up his Ext.10 after one of his employees answers him via hands free answer back.
So after about 25 seconds the Ext. 10 which originated the all page starts getting an obnoxious busy tone type of warble?
Any ideas on programming an auto disconnect situation?
So my new question is: Does the IP Office release 9 have a programmable time out field for the paging prompt?
Thank you all!
alwayslearning
alwayslearning
I put in an ACS R6 for customer who had an older IP Office ( not sure if it was the original type?) that he did not like.
He had an existing Viking PA2A paging / loud ringer combo already setup.
Now when he hits the all page button I think it is *70, but it may be *71?
Anyhow, because he is an older gentleman he does not hang up his Ext.10 after one of his employees answers him via hands free answer back.
So after about 25 seconds the Ext. 10 which originated the all page starts getting an obnoxious busy tone type of warble?
Any ideas on programming an auto disconnect situation?
So my new question is: Does the IP Office release 9 have a programmable time out field for the paging prompt?
Thank you all!
alwayslearning
alwayslearning
