Viking Door opener/ Magix in the Key Mode 1

[papagigo1]

I have a Viking door opener attacked to a port (co trunk port 806) in a Magix 4.0 V7 set in the Hybred Mode now and It works great.
I need to reconfig the Magix and end up in the Key mode. What do I need to do to allow a few analog extensions access to this trunk port to open the door?

Thanks in advance,
Mike

 

[merlinman]

If you do not have OVERHEAD Paging, you can program it as a PAGING PORT and they can just do a PICK UP of that line.

(#9 Line Number)

Of course there are a couple of very good ways to do this.

1 way:

You could renumber the line from 8xx to 5 or 6 or something, depending on your dial plan. Then they would dial #95 (or 6)

OR, you could program an inside auto dial to #01 that would do this if they dialed #01.

That is, you could program #01 (Personal Speed Dial 1) to be *22 PAGING LINE NUMBER (8xx 5 or 6).

http://home.comcast.net/~merlinman

 

[papagigo1]

Thanks Merlin Man,

As you can see by the question, I'm changing the switch back to Key. I had the opener working in a pool, but they insisted it was too complicated to use.

Good tip, I'll try it in the morning.

Mike
(Caribou Maine)

 

[papagigo1]

Merlinman,

The "loudspeaker Page" feature worked on the Viking Door opener. As you suggested I changed Loudspeaker Page port 806 to just 6, so #96 was the access code from any analog sets.

Thanks alot !

Mike

 

[merlinman]

You are very welcome.

Thanks for the compliment.

http://home.comcast.net/~merlinman