octavian10
MIS
I am trying to setup a VG202 as an MGCP gateway with CallManager. I cannot get the FXS ports to register with the CM. When I run show ccm-manager on the gateway it says Registered but the History Error Log shows:
voice-port 1/0
no shut
voice-port 1/0
signal loopstart
It seems like the CM is trying to no shut the FSX port and apply the loopstart command. Whats interesting is that its trying on voice-port 1/0??? The VG202 sees the port as 0/1 not 1/0. Has anyone seen this before?
"I hear and I forget. I see and I remember. I do and I understand."
- Confucius (551 BC - 479)
voice-port 1/0
no shut
voice-port 1/0
signal loopstart
It seems like the CM is trying to no shut the FSX port and apply the loopstart command. Whats interesting is that its trying on voice-port 1/0??? The VG202 sees the port as 0/1 not 1/0. Has anyone seen this before?
"I hear and I forget. I see and I remember. I do and I understand."
- Confucius (551 BC - 479)
