Vewing Script Code while Script runs??

[esoare]

Hi all,

The subject pretty much is the question.

Can you veiw the code in a side bar while the sript runs?

I notice that the Debug when you stop a script, shows the line and what code it was at when you stop a script. Is there some debug command, that will show what line you are on as the script runs?

At bit redundant, but hey, it's only tues.

Hope everyone is having a great Thanksgiving prep time!

es

 

[knob]

If you have a breakpoint command in your script, and it is compiled as debug, you can either step through your script line by line, or have it execute until it hits the next breakpoint. I have more information on this feature at the link below:

http://www.aspectscripting.com/debug.shtml

http://www.aspectscripting.com

 

[esoare]

Thanks knob! The Ctrl+Break is just what I needed, it helps out with not programming it into the script!

I would sometimes stop a script in debug, but the "continue/step" were greyed out.

Thanks again for your time!

Eugen