verify patch's

[ahannigan]

I am looking to see if my pbx has the correct patch's for a deployment i am working on with MS OCS 2007. This would be a c-1000, via TTY term. Does anyone know the command that i can use to see if i have the proper patch's
Thanks

 

[tnphoneman]

This is done with the MIRCC tool on the nortel patch library web site. There is no command on the PBX to determine if you have the correct patches. The PBX does not know. All it can do is tell you what is installed.

ld 22 issp

ld 143 mdp issp

Signature===========================================
Artificial Intelligence Is No Match for Natural Stupidity.

The latest survey shows that 3 out of 4 people make up 75% of the population.

The original point and click interface was a Smith & Wesson.

Red meat is not bad for you, it is the green fuzzy meat that is bad.

 

[ahannigan]

If I need to apply patch's that are not listed in LD 143, how is that done?

 

[tnphoneman]

Unless you get a new deplist then it is done through PDT.

Before you ask if you have never done this you will not get the password to get in there here.

Your vendor should be able to get this done for you. Deplists are installed via ld 143

Signature===========================================
Artificial Intelligence Is No Match for Natural Stupidity.

The latest survey shows that 3 out of 4 people make up 75% of the population.

The original point and click interface was a Smith & Wesson.

Red meat is not bad for you, it is the green fuzzy meat that is bad.

 

[ahannigan]

thanks so much, will go the vendor route.