Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
/var at capacity
- Thread starter Rosesam
- Start date
Firebird Scrambler
Systems Engineer
Have you recently done a full backup?. If so, what was the file size. If it was a large file, then it could be that it's nearing capacity on the disk.
I've had a few cases where I had to delete some of the CDR data as every backup contains all the call data. You can reduce the size quite a bit by removing data as it's probably not needed for historical reasons.
This can easily be done via the command line interface such as "PuTTY" etc.
Firebird Scrambler
Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer
Website = linkedin
I've had a few cases where I had to delete some of the CDR data as every backup contains all the call data. You can reduce the size quite a bit by removing data as it's probably not needed for historical reasons.
This can easily be done via the command line interface such as "PuTTY" etc.
Firebird Scrambler
Nortel & Avaya Meridian 1 / Succession & BCM / Norstar Programmer
Website = linkedin
curlycord
Programmer
What evidence shows that it is full? an alarm? what alarm code?
When you first installed it did you just re-program or did you do level 1/cold reset to wipe out old programming?
CDR would indeed most likely be the culprit, delete them....I will email you.
=----(((((((((()----=
Toronto, Canada
Add me to LinkedIN
When you first installed it did you just re-program or did you do level 1/cold reset to wipe out old programming?
CDR would indeed most likely be the culprit, delete them....I will email you.
=----(((((((((()----=
Toronto, Canada
Add me to LinkedIN
- Thread starter
- #5
- Status
Similar threads
- Locked
- Question
- Locked
- Question